Diplomat Adp8322 Professional Paid Advice

I then bent the plug connections down so that it would have a better contact with the PCB.

What do i use to adjust the back legs on diplomat dishwasher it says in the manual the rear feet are adjusted by the front studs they dont seem to move so how do i adjust or is there a tool i should use.

Dishwasher Fault Hi, My dishwasher is a Diplomat ADP8322 (which i think is a rebadged whirlpool unit) has been playing up recently.

Search: Fixed for free Popular These categories may also be of interest.

Help someone Are you good at fixing things To help Fault info.

Howtomendit.com costs nothing to use and you can ask a question without an account or logging in.

Answers Who answers the questions Other users of howtomendit.com provide the answers.

The more detail and information you provide in your question the easier it is for others to help you.

DIPLOMAT ADP 8322 DISHWASHER FAULT RECENTLY MY DIPLOMAT ADP 8322 DISHWASHER HAS STARTED BEEPING 5 MINS INTO A WASH CYCLE AND WHEN I OPEN THE DOOR THE RINSE CYCLE LIGHT IS ON ANY IDEAS BOYS THE DON September 2007 FA is flashing on my panel.

Julie December 2016 My dishwasher of this type starts but stops 1 minute later.

Mark March 2016 Followed instructions for removing side panel checking psb and small plug machine now working tried it three times before putting back together easy job.Thankyou Sylvia January 2015 Making much more noise than it used to and the tablet is always found intact in the cutlery basket and the contents of the dishwasher still dirty Thomas January 2013 Mine stopped working.

Now working fine.

Andy Lund September 2012 Hi,my diplomat dishwasher has stopped working there are no lights on door and there is still water in the bottom.

HELP what do i do.

Nigel from Bedford August 2012 machine has stopped working.

What could be the problem Trev August 2011 Any help available for a diplomat add 8322 that clicks off house rcd after 20 mins of working fine GraF July 2011 Ive read a bit about problems like this and manaaged to fix my ADP8322.

This indicates a fault number (flash 4 times, pause, flash 4 times F4).

Diplomat Adp8322 Professional Paid Advice

After searching around quite a bit and asking for professional paid advice via (justanswer.com - paid for service for reasonable price - 11 in my case) I found that it was a problem with a small circuit board (also known as a PCB - printed circuit board) which has a micro reed switch (part of the flowmeter).

How it works is once water comes through into the machine and spins a wheel, this then has some affect on the reed switch (I think it opens it).

This tells the machine that water is flowing into the dishwasher.

This PCB is found on the left hand side of the machine under the casing.

In order to do do this, you will need a special tool which you can buy from most hardware stores.

Once you have the side off, you will see a big plastic container where the water comes in.

On the bottom of this is a connection and the PCB in question.

You can remove the PCB altogether without damaging it if you pull it out gently with some needle nose tweezers.

On this connection the contact between the PCB and the plug is probably dirty and you need to clean this.

I scratched the circuit board connections with a screwdriver and then scratched the plug connections.

Diplomat Adp8322 Manual